TIDEWAY 1/4” Shank Double-edged Woodworking Milling Cutter Router Bit

• Specially prepared for bench trimming machine, portable engraving machine and so on.
• No polishing, smooth cutting, no burrs, no burrs, no blackening.
• Wide range of applications, such as factory building materials, home shops, carpentry enthusiasts.
• The
  blade is made of high quality hard alloy and has been carefully
  designed, developed and tested, which makes the blade sharper and
  improves the service efficiency and durability.

Operation precautions:

• The
  woodworking milling cutter is specially designed for the portable and
  desktop woodworking engraving machine, and cannot be used in the machine
  like electric drill, drilling machine and so on.
• Cutting tools
  can produce smooth surface for wood such as hardwood, softwood and
  synthetic board, but should avoid processing metal materials such as
  copper and iron as well as non-wood materials such as sand and stone.
• Make
  sure to use the clamping sleeve of appropriate size, because it is worn
  seriously, not round enough and with taper of inner bore cannot provide
  enough clamping strength, which leads to vibration or fly off when the
  blade handle is broken.
• Never assume that the new jacket is safe
  and reliable.When uneven contact marks or grooves are found in the
  handle part after clamping, slip situation and inner hole deformation of
  the clamp should be replaced immediately to avoid accidents.
• When
  the cutter is installed and clamped, stop the machine immediately if it
  is found that the knife has a fluttering phenomenon when working.
  Repeat the clamping for several times so that the tool handle and the
  clamping sleeve are in full contact and the work is carried out.
• The
  tool handle should be in good contact with the clamping sleeve, and the
  tool handle must be fully inserted into the clamping sleeve and
  tightened firmly, so as to provide sufficient clamping force for the
  tool.A small part should not only be inserted into the sleeve, otherwise
  it may cause breakage of the shank and damage to the cutter.
• Appropriate research and ear protection devices should be used during operation.